HP Tru64 UNIX and TruCluster Server Version 5.1.B-4 Patch Summary and Release Notes (13156)

# /etc/dn_fix_dat.sh
3. Reboot normally.
If you also need to reverse the version switch as described in “Script Required to Reverse Version
Switch”, run the /etc/dn_fix_dat.sh script after step 5 in that process.
Because the no-roll procedure automatically boots your system, you cannot use that patch kit
removal method if doing so would restore your system to a pre-patched state
Note:
If during the dupatch installation and deletion processes you see a Special Instruction about
running this script, you should ignore that instruction unless your system meets the requirement
described here.
2.2.3 Cluster-Specific Installation and Removal Release Notes
This section provides information you need to be aware of if you are installing or removing patch
kits from a TruCluster Server environment.
2.2.3.1 dupclone Error Message Can Be Ignored (new)
Installing this kit using the dupclone process on systems that do not have all of the operating
system and TruCluster Server base subsets installed may result in a messages similar to the
following to be displayed:
Problem installing:
- Tru64_UNIX_V5.1B:
Patch 27034.00
requires the existence of the following un-installed/un-selected subset(s):
- Tru64_UNIX_V5.1B:
Patch 27023.00
- Tru64_UNIX_V5.1B:
Patch 27050.00
.
.
.
You can ignore this message. In all cases, the subsets will be installed correctly.
See “Cluster Cloning Offers Alternative to No-Roll Patching” (page 15) for an introduction to
dupclone.
2.2.3.2 Installed CSP Could Affect dupatch Cloning Process (new)
If you have installed customer-specific patches (CSPs) on your system, you may see a message
similar to the following when installing this kit using the dupatch cloning process, at which
time the cloning process will be terminated:
Inspecting 69 patches for possible system conflicts ...
./usr/bin/ls:
is installed by Customer Specific Patch (CSP):
- Tru64_UNIX_V5.1B / Installation Patches:
Patch 01682.00 - Fix for dupatch command
and can not be replaced by this patch. To install this patch,
38 Kit Installation and Removal