Internet Express for Tru64 UNIX Version 6.8 Installation Guide (14234)

2 Installing Internet Express
You can use either a browser-based interface or a command-line interface to perform the Internet
Express installation. This chapter shows the browser-based procedure.
To control the progress of the browser-based installation procedure, and for data collection on
some of the forms in the Administration utility for Internet Express, your browser must be
enabled to use JavaScript.
Section 1.3: Internet Express Components and Subsets lists and describes the Internet
Expresscomponents. If you choose to install all the components, the installation can take up to
45 minutes.
Note:
Update installations from Internet Express Version 6.6 and Version 6.7 to Internet Express Version
6.8 are fully supported.
You can rerun the browser-based installation procedure at any time to change the subsets that
are installed on your system. The script verifies that the system configuration is correct, and then
presents an interactive menu for installing, updating, or removing subsets.
Note:
Some subsets are required by other subsets and cannot be removed unless the subsets that depend
on them are also removed.
You can also use the Administration utility after installation to install or remove subsets.
Note:
The command-line installation procedure only allows you to install subsets. To remove subsets,
use one of the following:
• ix_install in browser mode
• Administration utility. Choose Install/Remove Components on the Manage Components
menu.
• setld command
• ix_cleanup script (Section 3.3: Using the Cleanup Script) — This script is only used for
removing components.
2.1 TruCluster Server Support
If you are installing Internet Express on a cluster running TruCluster Server Version 5.0 or higher,
the following notes apply:
• Any member-specific configuration will automatically be performed for all cluster members
at installation time. If Internet Express is installed on a noncluster system that is subsequently
upgraded to a cluster system, all services will be automatically reconfigured to run properly
in a cluster as part of the cluster upgrade process.
• During installation, performance tuning recommendations will be made for all cluster
members, but no action can be taken. To make modifications, use the Administration utility
for Internet Express.
2.2 Verifying the Installed Version of Tru64 UNIX
Before you begin the installation procedure, make sure that you have a complete backup of your
system.
2.1 TruCluster Server Support 19