Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

4–10 HSG80 ACS Solution Software Version 8.6 for Compaq Tru64 UNIX Installation and Configuration Guide
CAUTION: After you make a change to the configuration, such as adding a client
system, you must stop and then start the Agent for your changes take effect. When
you stop and then start the Agent, the Storage Windows for the subsystems
connected to the agent system lose their connection. To regain that connection, close
and then reopen the Storage Windows connected to the agent system after you restart
the Agent.
Table 4–6 Information Needed to Configure Agent
Term/Procedure Description
Adding a Client system entry For a client system to receive updates from the Agent, you must
add it to the Agent’s list of client system entries. The Agent will
only send information to client system entries that are on this list.
In addition, adding a client system entry allows you to access the
Agent system from the Navigation Tree on that Client system.
Adding a subsystem entry You need to tell the Agent the subsystem that it needs to monitor.
Client system Network names for the computers on which the Client software
runs.
Client system access options The access privilege level controls the Client system’s level of
access to the subsystems.
0=No Access
−Can use the Client software to add a system to a
Navigation Tree, set up a pager, and view properties of the
controller and the system. You cannot use Client to open a
Storage Window.
1=Show Level Access
−Can use the Client software to open a
Storage Window, but you cannot make modifications in that
window.
2=Storage Subsystem Configuration Capability
−Can use the
Client software to make changes in a Storage Window to modify a
subsystem configuration.