Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

5–4 HSG60 ACS Solution Software Version 8.6 for Compaq Tru64 UNIX Installation and Configuration Guide
Figure 5–2. Single controller cabling
Configuring a Single Controller Using CLI
To configure a single controller using CLI involves the following processes:
■ Verify the Node ID and Check for Any Previous Connections.
■ Configure Controller Settings.
■ Restart the Controllers.
■ Set Time and Verify All Commands.
■ Plug in the FC Cable and Verify Connections.
■ Repeat Procedure for Each Host Adapter Connections
■ Verify Installation
Verify the Node ID and Check for Any Previous
Connections
1. Enter a SHOW THIS command to verify the node ID:
SHOW THIS
1 Controller
2 Host port 1
3 Host port 2
4 Cable from the switch to the host Fibre Channel adapter
5 FC switch
CXO6881B
1
5
5
3
2
4
4