Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

Chapter 7
Configuration Example Using CLI
This chapter presents an example of configuring a particular storage subsystem using the
CLI. The CLI configuration example shown assumes:
■ A normal, new controller pair, meaning:
❏ NODE ID set
❏ No previous failover mode
❏ No previous topology set
■ Full array with no expansion cabinet
■ PCMCIA cards installed in both controllers
A storage subsystem example is shown in Figure 7–1. The example system contains three
non-clustered TRU64_UNIX hosts, as shown in Figure 7–2. From the hosts’ point of
view, each host will have four paths to its own virtual disks. The resulting virtual system,
from the hosts’ point of view, is shown in Figure 7–3.
Figure 7–1 shows an example storage system map for the 4214R enclosure. Details on
building your own map are described in Chapter 2. Templates to help you build your
storage map are supplied in Appendix A.