Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

Chapter 8
Backing Up the Subsystem, Cloning Data for
Backup, and Moving Storagesets
This chapter describes some common procedures that are not mentioned previously in
this guide. The following information is included in this chapter:
■ “Backing Up the Subsystem Configuration,” page 8–1
■ “Cloning Data for Backup,” page 8–2
■ “Moving Storagesets,” page 8–5
Backing Up the Subsystem Configuration
The controller stores information about the subsystem configuration in its nonvolatile
memory. This information could be lost if the controller fails or when you replace a
module in the subsystem.
You can use the following command to produce a display that shows if the save
configuration feature is active and which devices are being used to store the
configuration.
SHOW THIS_CONTROLLER FULL
The resulting display includes a line that indicates status and how many devices have
copies of the configuration. The last line shows on how many devices the configuration
is backed up.
The SHOW devices FULL command shows which disk drive are set up to back up the
configuration. The syntax for this command is shown below:
SHOW DEVICES FULL