Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

Backing Up the Subsystem, Cloning Data for Backup, and Moving Storagesets 8–3
Figure 8–1. Steps the CLONE utility follows for duplicating unit members
Use the following steps to clone a single-disk unit, stripeset, or mirrorset:
1. Establish a connection to the controller that accesses the unit you want to clone.
2. Start CLONE using the following command:
RUN CLONE
3. When prompted, enter the unit number of the unit you want to clone.
4. When prompted, enter a unit number for the clone unit that CLONE will create.
5. When prompted, indicate how you would like the clone unit to be brought online:
either automatically or only after approval.
6. When prompted, enter the disk drives you want to use for the clone units.
Unit
Disk10300
Unit
Disk10300
Clone of Disk10300
Clone Unit
Temporary mirrorset
Unit
Disk10300
New member
Unit
Disk10300
New member
Temporary mirrorset
CXO5510A
C
o
p
y