Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

Installing and Configuring the HS-Series Agent 4–7
The notification scheme defines the network protocol to be used by the Agent when
notifying the selected client system of a change in the state of a subsystem. The
following describes how the Transmission Control Protocol/Internet Protocol (TCP/IP)
and the Simple Network Management Protocol (SNMP) work with SWCC.
12. Press press the Enter key.
The computer asks you if the entered information is correct.
13. Select option y and then press press the Enter key.
A message, asking if you would like to add another Client, appears.
14. To stop adding client systems, select option n and press the Enter key.
You are asked for a password, which is required to do configurations within the Client
software. If an old password is found, you are asked if you want to use it.
Enter Subsystem Information
15. Enter your case-sensitive password that has 4 to 16 characters, and press the Enter
key. You are asked to retype the password.
16. Retype the password and press the Enter key.
Once the password has been entered, the system scans for subsystems. You will be
asked for the name and monitoring interval of each RAID subsystem found.
17. Enter the subsystem name in lowercase letters, and press the Enter key. You are asked
for the monitoring interval. The monitoring interval is the rate at which the Agent
queries the specified subsystem for status.
Table 4–4 Client System Notification Options
Options SWCC Function
Transmission control Protocol/Internet Protocol
(TCP/IP)
■ Automatically updates the Storage Window of
subsystem changes provided AES is running
■ Required for Windows NT event logging and
pager notification
■ If you do not select TCP/IP, you will need to
refresh the Storage Window (depending on the
subsystem) to obtain the latest status of a
subsystem.
Simple Network Management Protocol (SNMP) ■ Requires you to use an SNMP-monitoring
program to view SNMP traps