Software Owner manual

NOTE: For VC firmware versions 3.7x and later, you cannot select the same network for
more than one mapped physical port such as LOM1 and LOM2 for example. VCEM returns
an error similar to the following:
Ethernet connections 2, 4 are mapped to the same physical port (LOM:2). These connections are configured
with duplicate networks. Please ensure there are no duplicate networks on connections mapped to the same
physical port.
7. Select Add iSCSI Connection in the Flex-10 iSCSI connections table to add network names,
port speed and boot settings.
Figure 63 (page 102) displays iSCSI boot settings.
Figure 63 iSCSI boot settings
If you enter an incorrect field format, an error message with the appropriate format is displayed.
The following table describes iSCSI boot setting attributes and field formatting.
DescriptionSetting
iSCSI Boot Configuration
Name used for the iSCSI initiator boot system. The
initiator name length is maximum of 256 characters. If
Initiator Name (required)
the initiator name contains nonalphanumeric characters,
it must be enclosed in double quotes. The value must be
in the following format:
iqn.yyyy-mm.{domain.name} See http://
docs.hp.com/en/T1452-90011/ch04s01.html for more
information.
Boot target. The target name length is a maximum of
256 characters. If the name contains nonalphanumeric
Target Name (required)
characters, it must be enclosed in double quotes. The
value must be in the following format:
iqn.yyyy-mm.{domain.name} See http://
docs.hp.com/en/T1452-90011/ch04s01.html for more
information.
102 Managing server profiles