Software Owner manual

Figure 9 Firmware update message
After the job completes, use the VCSU to perform the firmware update and then proceed to
Step 4.
4. Check mark the targeted VC Domains on the VC Domain tab and select VC Domain Firmware
Update... again.
NOTE: If another VC Domain with a status other than Firmware update is selected, the VC
Domain Firmware update button is disabled.
5. Select Complete Firmware update to finish the firmware update process (Figure 10).
Figure 10 Completing the Firmware Update process
You may want to upgrade the VC Domain Group firmware after updating the VC firmware. See
“Upgrading VC Domain Group firmware mode” (page 86) for more information.
Updating to VC firmware 3.7x or later
CAUTION: Do not update to VC firmware 3.7x or later if the VC Domain Group firmware mode
is 3.15. This is because VC firmware 3.7x or later is not compatible with VC firmware 3.15. If
you update to VC firmware 3.7x or later, your only options are to either remove the updated VC
Domain from the VC Domain Group, or to use VCSU to downgrade the VC Domain firmware to
the previous version.
HP recommends that you update to the VC Domain Group firmware version to VC firmware 3.30
or later before attempting to update a VC Domain in the VC Domain Group to VC firmware 3.7x
or later. For more information, see “Updating VC firmware versions in a VC Domain to be
compatible with VC 3.7x or later” (page 160).
24 Installing and configuring VCEM