HP Insight Management WBEM Providers for HP integrated VMware ESXi 5.0 U1 June 2012 Profiles

Version 2.1.1 15
7.7 CIM_ConcreteIdentity (Optional)
CIM_ConcreteIdentity is an optional class. It is only instantiated if the provider supports the association
from CIM_ManagementController and CIM_PCIDevice instance.
8 Methods
8.1 Method: HP_ManagementProcessor.RequestStateChange() Optional
Implementations may support the RequestStateChange method to change the state of the management
processor. If implemented, the provider should support the “RequestedState” property with a value of 11
(Reset). Support of the “Job” and “TimeoutPeriiod” parameters are optional.
8.2 Profile Conventions for Operations
Support for operations for each profile class (including associations) is specified in the following sub-
clauses. Each sub-clause includes either a statement “All operations are supported as described by
DSP200 v1.2” or a table listing all the operations that are Unspecified by this profile or where the profile
requires behavior other that described by DSP200.
The default list of operations is as follows:
• GetInstance
• Associators
• AssociatorNames
• References
• ReferenceNames
• EnumerateInstances
• EnumerateInstanceNames
A compliant implementation shall support all the operations in the default list for each class, unless the
Requirements column states something other than Mandatory.
8.3 HP_ManagementProcessor
Table 3 lists operations that either have special requirements beyond those from DSP0200 or shall not be
supported. All other operations may be supported as defined in DSP0200.
Table 3 – Operations: HP_ManagementProcessor
Operation
Requirement
Messages
GetInstance Mandatory None
Associators Unspecified None
AssociatorNames Unspecified None
References Unspecified None
ReferenceNames Unspecified None
EnumerateInstances Unspecified None
EnumerateInstanceNames Unspecified None