HP Insight Management WBEM Providers for HP integrated VMware ESXi 5.0 U1 June 2012 Profiles

Version 2.1.0 21
• If all paths on all disks are set to 5 (Path Error) then:
o OperationalStatus[0]: 6 (error)
o OperationalStatus[1]: 32771(0x8003) (
Physical Path In Error)
The below values shows the possible OperationalStatus[1] values to account for transient data drive and
rebuilding of a physical drive.
• If the disk is in transient data drive status:
o OperationalStatus [0]: 2 (OK)
o OperationalStatus[1]:
0x8004 (Transient Data Drive)
•
If the disk is in the process of rebuilding it data due to becoming an active spare or recovering
from a previous failure
:
o OperationalStatus [0]: 2 (OK)
o OperationalStatus[1]:
0x8005 (Rebuild)
The below values shows the possible OperationalStatus [1] values to account for Solid State drive wear
out.
• If the Solid state drive reports a Smart Trip due to wear out then:
o OperationalStatus[0]: 5 (
Predictive Failure)
o OperationalStatus[1]: 0x8006 (
Solid State drive wear out)
The below values shows the possible OperationalStatus [1] values to account for Physical Drive
Authentication.
• If the physical drive reports a authentication failure then:
o OperationalStatus [0]: 3 (Degraded)
o
OperationalStatus[1]: 0x8007(Not Authenticated)
NOTE: The properties from section 7.1.6 till 7.1.9 are conditionally populated only if the controller
firmware and disk drive firmware support reporting drive life parameters for Solid State Disk Drives.
Otherwise, these property values will be empty.
If the firmware supports reporting these parameters can be verified using SSDWearStatus property. If this
property value is set to “Unknown”, it implies that the provider is unable to determine the physical drive’s
solid state disk drive life parameters.
7.1.7 HPSAS_DiskDrive.SSDTotalPowerOnHours
This value indicates the total number of hours that the Solid State Disk has been powered on. This
property will only be available if the controller firmware supports reporting of solid state drive life
information.
7.1.8 HPSAS_DiskDrive.SSDPercentageEnduranceUsed
This value reports the Physical Drive Solid State Percent Endurance Used as integer. This property will
only be available if the controller firmware supports reporting of solid state drive life information.
7.1.9 HPSAS_DiskDrive.SSDLifeRemaining
This value indicates the Solid State drive life remaining days until wear out. This property will only be
available if the controller firmware supports reporting of solid state drive life information.