P00121_-_HP_Smart_Array_Profile

34 Version 1.3.001
Value
ValueMap
0
None
1
OK
2
Redundant Controller Cache Size Mismatch
3
Cache Disabled Expand In Progress
4
Cache Disabled Low Batteries
5
Cache Disabled Low Resources
6
Error Reading Cache Board
7
Requires Reboot To Enable Cache
8
Cache Disabled Run ADU
9
Cache Disabled Snapshot In Progress
10
Error Writing Cache Board
11
Wrong Cache Board Attached
12
Possible Data Loss From Low Battery
13
Error Detected Run ADU
14
Valid Data In Cache Board Found
15
Cache Disabled capacitor charge is low
16
Cache Disabled capacitor is not attached
17
capacitor-based cache module backup operation
failed
18
capacitor-based cache module restore operation
failed
19
capacitor-based cache module hardware failure
20
capacitor-based cache module capacitor failed to
charge
HPSA_ArrayController.ControllerStatus
This enumeration will be used to indicate the status returned by the controller.
Table 11 – HP Smart Array profile: HPSA_ArrayController.ControllerStatus
Value
ValueMap
0
Unknown
1
Other
2
OK
3
ERROR
7.2 HPSA_ArraySystem
The HPSA_ArraySystem class has been extended form the CIM_ComputerSystem class as defined in
SNIA Array/HHRC profiles and shall be instantiated to represent the top level system.
7.2.1 HPSA_ArraySystem.Identify(uint32 Duration)
This method will cause all hard drives connected to this controller to set some indicator (e.g. set or blink
drive LEDs) for the given duration (default duration is 30 seconds). After the duration has expired the
drive indicator(s) will return to normal use.
Return values for Identify() method shall be as specified in Table 12 where the method execution
behavior matches the return code description.