HP MPIO Full Featured DSM for EVA4x00/6x00/8x00 family of Disk Arrays 3.00.00 Installation and Reference Guide (AA-RW7SJ-TE, March 2008)
<install drive>:\MPInstall\setup.exe /s /f1"C:\setup.iss" /f2"C:\MPSInstallLog.txt"
The <install drive> refers to the drive which contains the installation media.
The setup.iss is the response file from which information is taken for silent installation.
The MPSInstallLog.txt file records information about the silent installation.
The ResponseResult section of the MPSInstallLog.txt log file displays the result code, indicating
whether or not the silent installation succeede d. An integer value is assigned to the ResultCode
keyname in the ResponseResult section.
Following are the list of common return values along with their descriptions in the ResultCode key:
Result Code
Description
0Success
–1
General error
–3
Required data not found in the setup.iss file
–4
Not enough memory available
–5
File does not exist
–6
Cannot write to the response file
–7
Unable to writ
etothelogfile
–8
Invalid path to the InstallShield Silent response (.iss) file
–51
Cannot create the specified folder
–52
Cannot access
the specified file or folder
NOTE:
The C: in /f1C: and /f2C: refer s to a local drive on the system or a network driv e which is used
to obtain the
response file and write the MPSInstallLog.txt (provided there is write permission
in the directory).
For 32 bit systems:
<Default_Target_Dir> = C:\Program Files\Hewlett-Packard\HP MPIO DSM\EVA
DSM
For 64 bit systems:
<Default_Target_Dir> = C:\Program Files (x86)\Hewlett-Packard\HP MPIO
DSM\EVA DSM
<User_Targe
t_Dir> = is a directory on the system on which the new installation is to be done or
the director
yofanexistinginstallation.
You must enclose the paths to the response file and the log file, which records the information about
the silent i
nstallation, in quotes ("").
Installing HP MPIO EVA DSM
To perform a silent installation of HP MPIO EVA DSM, complete the steps below:
1. Make a copy of the new.iss file in the installation kit.
2. Rename this copy of the file as setup.iss
3. Choose one of the following options:
• To install into the default directory for 64 bit systems, in lines 27 and 32 of the setup.iss
file, replace C:\Program Files\Hewlett-Packard\HP MPIO DSM\EVA DSM with
C:\Program Files (x86)\Hewlett-Packard\HP MPIO DSM\EVA DSM.
16
Installing the HP MPIO Full Featured DSM for EVA4x00/6 x00/8x00 family of Disk Arrays