HP MPIO Full Featured DSM for EVA4x00/6x00/8x00 family of Disk Arrays 3.00.00 Installation and Reference Guide (AA-RW7SJ-TE, March 2008)

Event ID Message
Description
112
The removal event
notifications for
multipath capable disk
X have been enabled upon
request.
This event is logged when generation of removal
event notifications (Event IDs 304, 302 and 108) for
the multipath capable disk with seri al number X has
been enabled upon request in the DSM.
113
The multipath capable disk
X has been disconnected
from the system.
This event is logged when the last path to a multipath
capable disk with serial number X (for which the
generation of removal event notifications have been
disabled) is disconnected from the system.
301
The DSM failed to
initialize during startup.
The DSM did not initialize successfully during
startup.
302
An unrecoverable path
failure occurred on SCSI
address Y. Disk X failed
due to no redundant paths
available.
All p aths to an existing multipath disk have failed.
X represents the serial number of the disk. Y is the
SCSI address of the last path that failed.
303
Too many paths for disk
with serial number X.
Path (SCSI address Y) not
added.
A new path in excess of the supported number
of paths for an existing multipath disk has been
discovered. X represents the serial number of the
disk. Y is the SCSI address of the newly found path.
304
An unrecoverable path
failure occurred on SCSI
address Y. Disk X is still
accessible over redundant
path(s).
A redundant path to an existing multi path disk has
failed. X represents the serial number of the disk. Y
is the SCSI address of the path that failed.
305
The DSM timed out on the
I/O throttle operation for
multipath capable disk X.
The DSM
was unable to successfully throttle I/O
activity within the time-out period, for the specified
multipath disk. X represents the serial number of
the dis
k.
307
An unrecoverable failure
has occurred on multipath
capable disk X. This disk
will henceforth not be
accessible.
This e
vent is logged when the DSM detects an
unrec
ov erable failur e of a multipath capable disk,
and requests MPIO not to support this disk going
forward. Please check the status of the multipath
capable disk at the array end. X represents the
seri
al number of the disk.
308
An unrecoverable failure
has occurred on multipath
capable disk X. The
data on this disk may
be inaccessible.
This
event is logged when the DSM detects an
unr
ecoverable failure of a multipath capable disk.
Although the disk may be visible to the system, the
data on the disk may not be acc essible. Please check
the
status of the multipath capable disk at the array
end. X represents the serial number of the disk.
309
The DSM cannot manage
multipath capable disk X
(SCSI address Y) due to an
internal error.
The DSM cannot manage multipath capable disk X
(SCSI address Y) due to an internal error.
40
Multipathing driver event log messages