Installation and Reference Guide for HP MPIO Full Featured DSM for MSA1000/1500 (Active-Active) Disk Arrays 3.00.00 (AA-RW8AD-TE, March 2008)
hpdsm devices a
ll
Syntax: hpdsm d
evices all
The hpdsm devices all command displays information of the device, followed by their path
information as shown in the following example. If there are no devices, the following message is
displayed: No d
evices found.
NOTE:
See hpdsm set device policy for a definition of the policies. The P.B.T.L. column shows the device port ,
bus, target, and LUN.
Example:
hpdsm devices all
Device#
Device Name Serial No.
Active
Paths
Policy
Disk#
P.B.T.L ALB
1
HP
MSA_VOLUME
6005008B5009013F0AA40492A2BE801B7 2
NLB
Disk1 3.0.0.12
N/A
Path# Controller Port#
State
HBA Slot#
RTP P.B.T.L
1 P56350GX3R10F6-1 Active
7
00010001 3.0.0.12
2 P56350FX3RQA03-1 Available 6 00010002 4.0.0.12
Device#
Device Name Serial No.
Active
Paths
Policy
Disk#
P.B.T.L ALB
2
HP
MSA_VOLUME
6005008B5009013F0AB40492A2BE801B8 2
NLB
Disk2 3.0.0.13
N/A
Path# Controller Port#
State
HBA Slot#
RTP P.B.T.L
1
P56350GX3R10F6-1 Active
7
00010002 3.0.2.13
2 P56350FX3RQA03-1 Available 6 00010002 4.0.2.13
hpdsm paths device
Syntax: hpdsm paths device=x
The hpdsm paths device command displays information about the paths available for device x,as
shown in the following example.
NOTE:
• The P.B.T.L. colum n shows the device port, bus, target, and LUN.
• TheRTPcolumnshowsthetargetportinformationasdefined by SCSI-3 specification.
• The Controller Port# column shows the controller serial number followed by target port number.
22
Managing storage arrays using the HP MPIO MSA DSM with the CLI utility