HP MPIO Full Featured DSM for P6x00 family of Disk Arrays 4.04.00 Installation and Reference Guide (757324-001, May 2014)

The hpdsm devices all command displays the information of the device, followed by their
path information as shown in the following example. If there are no devices present, the following
message is displayed: No devices found.
NOTE: See “hpdsm set device policy”for a definition of the policies. The P.B.T.L. column shows
the device port, bus, target, and LUN.
Example:
hpdsm devices all
Total No. of Devices:2
Device Name:HP HSV210Device#:1
Active Paths: 2Serial No:6005008B400101F6000170000
Disk 1Policy:NLB
ALB:NP.B.T.L:2.0.3.1
P.B.T.LRTPHBA
Slot#
StateController Port#Path#
*3.0.2.3000100027ActiveP898DXAAQQO101U-21
4.0.2.3000100026AvailableP898DXAAQQO101U-22
Device Name:HP HSV210Device#:2
Active Paths: 2Serial No:6005008B400101F600018000
Disk 2Policy:SQST-Subset
ALB:NP.B.T.L:3.0.2.4
P.B.T.LRTPHBA
Slot#
StateController StatePath#
3.0.2.4000100027ActiveP898DXAAQQO101U-21
4.0.2.4000100026AvailableP898DXAAQQO101U-22
hpdsm paths device
Syntax: hpdsm paths device=x
The hpdsm paths device command displays information about the paths available for device
x, as shown in the following example.
16 Managing storage arrays using the HP MPIO EVA DSM with the CLI utility