HP MPIO Full Featured DSM for P6x00 family of Disk Arrays 4.04.00 Installation and Reference Guide (757324-001, May 2014)

Example:
hpdsm set device=1 subset=add path=all
Device Name:HP HSV210
Device Serial No.:600508B400101F6A000070001D950000
Change Subset setting (y/n)? y
Subset setting changed. Verify by using "hpdsm devices" command.
Example:
hpdsm set device=all subset=remove path=1
Successful for all the devices. Verify by using "hpdsm devices" command.
NOTE:
device=all changes the SUBSET STATE for all the devices
path=all enables or disables subset settings and adds or removes all the available paths
to or from the subset
Paths in the failed state cannot be added or removed to or from the subset
hpdsm set device=x subset=remove path=all will cleanup the failed paths and
disables the subset
hpdsm set device alb
Syntax: hpdsm set device=x alb=y/n
Syntax: hpdsm set device=all alb=y/n
The hpdsm set device alb command changes the Adaptive Load Balance setting for the
device x or for all the devices depending on the input parameter specified.
Example:
hpdsm set device=1 alb=y
Device Name:HP HSV210
Device Serial No.:600508B400101F6A000070001D950000
Change Adaptive Load Balance setting (y/n)? y
ALB settings changed. Verify by using "hpdsm devices" command.
Example:
hpdsm set device=all alb=y
Successful for all the devices. Verify by using "hpdsm devices" command.
hpdsm set device path
Syntax: hpdsm set device=x path=y
The hpdsm set device path command changes the preferred path for device x, as shown in
the following example.
NOTE: Use the hpdsm paths device command to view the available paths for the device.
hpdsm set device=1 path=1
Device Name:HP HSV210
Device Serial No.:600508B400101F6A000070001D950000
Controller Port No.:P8398DXAAQQ013
Change Load Balance policy (y/n)? y
Preferred Path changed. Verify by issuing "hpdsm paths device=<number>" command.
hpdsm cleanup device
Syntax: hpdsm cleanup device=x
Syntax: hpdsm cleanup device=all
18 Managing storage arrays using the HP MPIO EVA DSM with the CLI utility