HP MPIO Full Featured DSM for P6x00 family of Disk Arrays 4.04.00 Installation and Reference Guide (757324-001, May 2014)

Table 6 HP MPIO EVA DSM event log messages (continued)
DescriptionMessage
Event
ID
This event is logged when the last path to a multipath
capable disk with serial number X (for which the
The multipath capable disk X has been
dis connected from the system.
114
generation of removal event notifications have been
disabled) is disconnected from the system.
The DSM did not initialize successfully during startup.The DSM failed to initialize during
startup.
301
All paths to an existing multipath disk have failed. X
represents the serial number of the disk. Y is the SCSI
address of the last path that failed.
An unrecoverable path failure occurred
on SCSI address Y. Disk X failed due
to no redundant paths available.
302
A new path in excess of the supported number of paths
for an existing multipath disk has been discovered. X
Too many paths for disk with serial
number X. Path (SCSI address Y) not
added.
303
represents the serial number of the disk. Y is the SCSI
address of the newly found path.
A redundant path to an existing multipath disk has failed.
X represents the serial number of the disk. Y is the SCSI
address of the path that failed.
An unrecoverable path failure occurred
on SCSI address Y. Disk X is still
accessible over redundant path(s).
304
The DSM was unable to successfully throttle I/O activity
within the time-out period, for the specified multipath disk.
X represents the serial number of the disk.
The DSM timed out on the I/O throttle
operation for multipath capable disk
X.
305
This event is logged when the DSM detects an
unrecoverable failure of a multipath capable disk, and
An unrecoverable failure has occurred
on multipath capable disk X. This disk
will henceforth not be accessible.
307
requests MPIO not to support this disk going forward.
Please check the status of the multipath capable disk at
the array end. X represents the serial number of the disk.
This event is logged when the DSM detects an
unrecoverable failure of a multipath capable disk.
An unrecoverable failure has occurred
on multipath capable disk X. The data
on this disk may be inaccessible.
308
Although the disk may be visible to the system, the data
on the disk may not be accessible. Please check the status
of the multipath capable disk at the array end. X
represents the serial number of the disk.
The DSM cannot manage multipath capable disk X (SCSI
address Y) due to an internal error.
The DSM cannot manage multipath
capable disk X (SCSI address Y) due
to an internal error.
309
This event is logged when DSM detects that the path with
SCSI address Y is inconsistent and is moved to failed
The DSM detected an inconsistency in
the path (SCSI address Y) to the
310
state. X represents the serial number of the disk. A reboot
multipath capable disk X. This path
has been marked as failed.
of the system is recommended to overcome this
inconsistent state.
30 Multipathing driver event log messages