HP MPIO Full Featured DSM for SAN Virtualization Services Platform 4.01.00 installation and reference guide (5697-0237, January 2010)

6. Close the Add/Remove Programs window.
NOTE:
The LUNs may be inaccessible at this time.
7. Reboot the system.
NOTE:
For Windows Server 2008 Server Core and Microsoft Windows Server 2008 R2 Server Core, go to
the installation location from the command prompt and run Launch.exe. Select
Remove > Remove all installed components, to remove HP MPIO SVSP DSM.
Using silent installation
You can execute the silent installation from the installation location on your computer or from a network
drive. It installs the HP MPIO SVSP DSM with little intervention. Silent installation is useful if you are
installing the software on a large number of servers that require software installation.
Syntax:
<install_dir>:\MPInstall\setup.exe /s /f1"C:\setup.iss" /f2"C:\MPSInstallLog.txt”
The <install_dir> refers to the drive which contains the installation media.
The setup.iss is the response file from which information is taken for silent installation.
The MPSInstallLog.txt file records information about the silent installation.
The ResponseResult section of the MPSInstallLog.txt log file displays the resultant code,
indicating whether or not the silent installation succeeded. An integer value is assigned to the
ResultCode keyname in the ResponseResult section.
Following is the list of common return values along with their descriptions in the ResultCode key:
DescriptionResult Code
Success0
General error–1
Required data not found in the setup.iss file
–3
Not enough memory available–4
File does not exist–5
Cannot write to the response file–6
Unable to write to the log file–7
Invalid path to the InstallShield Silent response (.iss) file
–8
Cannot create the specified folder–51
Installing the HP MPIO Full Featured DSM for SAN Virtualization Services Platform16