HP MPIO Full Featured DSM for SAN Virtualization Services Platform 4.01.00 installation and reference guide (5697-0237, January 2010)

4 Managing storage devices using the HP
MPIO SVSP DSM with the CLI utility
The command line interface utility (CLI) of HP MPIO SVSP DSM enables you to monitor and manage
multipathing devices. This chapter describes the following CLI commands:
• hpdsm devices
• hpdsm devices all
• hpdsm paths device
• hpdsm set device policy
• hpdsm set device path
• hpdsm cleanup device
• hpdsm notify
• hpdsm help
hpdsm devices
Syntax: hpdsm devices
The hpdsm devices command displays information about the HP MPIO devices as shown in the
following example. If there are no devices present, the following message is displayed: No devices
found.
NOTE:
See hpdsm set device policy for a definition of the policies. The P.B.T.L. column shows the device port,
bus, target, and LUN.
Example:
hpdsm devices
ALBP.B.T.LDisk#Policy
Active
Paths
Serial No.
Device
Name
Device#
N/A3.0.0.1Disk 1NLB8600A0B80001111550000043AE3D6D548HP HSVX7001
N/A3.0.1.2Disk 2SQST8600A0B80001111550000F0C9E3D6D548HP HSVX7002
N/A6.0.3.3Disk 3SQST8600A0B80001111550000F34AE3D6D548HP HSVX7003
HP MPIO Full Featured DSM for SAN Virtualization Services Platform 4.01.00 installation and reference
guide 25