HP MPIO Full Featured DSM for SAN Virtualization Services Platform 4.01.00 installation and reference guide (5697-0237, January 2010)

hpdsm paths device
Syntax: hpdsm paths device=x
The hpdsm paths device command displays information about the paths available for device x,
as shown in the following example.
NOTE:
• The P.B.T.L. column shows the device port, bus, target, and LUN.
• The RTP column shows the target port information as defined by SCSI-3 specification.
• The Controller Port# column shows the controller serial number followed by target port number.
hpdsm paths device=1
P.B.T.LRTP
HBA
Slot#
StateController Port#Path#
3.0.0.1000200112Active00000724C00373-11
3.0.1.1000200152Available00000724C00373-52
3.0.2.1000100032Standby00000724C00519-33
3.0.3.1000100072Standby00000724C00519-74
7.0.0.1000200111Available00000724C00373-15
7.0.1.1000200151Available00000724C00373-56
7.0.2.1000100031Standby00000724C00519-37
7.0.3.1000100071Standby00000724C00519-38
hpdsm set device policy
Syntax: hpdsm set device=x policy=policy
Syntax: hpdsm set device=all policy=policy
The hpdsm set device policy command sets the load-balancing policy for device x or for all
device, depending on the input parameter specified.
The following example demonstrates the information displayed by the hpdsm set device policy
command.
Managing storage devices using the HP MPIO SVSP DSM with the CLI utility28