HP MPIO Full Featured DSM for SAN Virtualization Services Platform 4.01.00 installation and reference guide (5697-0237, January 2010)

hpdsm cleanup device
Syntax: hpdsm cleanup device=x
Syntax: hpdsm cleanup device=all
The hpdsm cleanup device command allows you to clean up the failed path information for a
specified device x or for all the devices, depending on the input parameters specified, as shown
in the following example.
Example:
hpdsm cleanup device=1
Device Name:HP HSV210
Device Serial No.:600508B400101F6A000070001D950000
Cleanup the failed path information for this LUN (y/n)? y
Cleanup Succeeded. Verify by issuing "hpdsm devices" command.
Example:
hpdsm cleanup device=all
Successful for all the devices. Verify by issuing "hpdsm devices" command.
hpdsm notify
Syntax: hpdsm notify event=notification_event_number time=number_of_minutes
The hpdsm notify command defines user notification of events. The time attribute defines the number
of minutes that elapses from the time the event occurs until the user is notified. The maximum value
that can be entered is 35000 minutes.
NOTE:
Syntax: hpdsm notify event=notification_event_number
The above command will make the notification to wait indefinitely until the user terminates the wait
(with Ctrl-C).
Managing storage devices using the HP MPIO SVSP DSM with the CLI utility30