HP MPIO Full Featured DSM for SAN Virtualization Services Platform 4.01.00 installation and reference guide (5697-0237, January 2010)

DescriptionMessageEvent
ID
This event is logged when generation of removal event
notifications (Event IDs 304, 302 and 108) for the
multipath capable disk with serial number X has been
enabled upon request in the DSM.
The removal event notifica-
tions for multipath capable
disk X have been enabled upon
request.
112
This event is logged when the last path to a multipath
capable disk with serial number X (for which the
generation of removal event notifications have been
disabled) is disconnected from the system.
The multipath capable disk X
has been disconnected from
the system.
113
This event is logged when a path to a multipath capable
disk with serial number X, is recovered from Unavailable
state. Y is the SCSI address of that path.
The path (SCSI address (Y))
for multipath capable disk X
has recovered from Unavail-
able state.
114
This event is logged when a path to a multipath capable
disk with serial number X, has become Unavailable. Y is
the SCSI address of that path.
The path (SCSI address (Y))
for multipath capable disk X
has become unavailable.
201
This event is logged when the volume failover
command issued over a path to a multipath capable disk
with serial number X, has failed. Y is the SCSI address of
that path.
The volume failover command
issued over the path (SCSI
address (Y)) for multipath
capable disk X has failed.
202
The DSM did not initialize successfully during startup.
The DSM failed to initialize
during startup.
301
All paths to an existing multipath disk have failed. X rep-
resents the serial number of the disk. Y is the SCSI address
of the last path that failed.
An unrecoverable path failure
occurred on SCSI address Y.
Disk X failed due to no re-
dundant paths available.
302
A new path in excess of the supported number of paths
for an existing multipath disk has been discovered. X
represents the serial number of the disk. Y is the SCSI
address of the newly found path.
Too many paths for disk with
serial number X. Path (SCSI
address Y) not added.
303
A redundant path to an existing multipath disk has failed.
X represents the serial number of the disk. Y is the SCSI
address of the path that failed.
An unrecoverable path failure
occurred on SCSI address Y.
Disk X is still accessible
over redundant path(s).
304
This event is logged when the DSM detects an unrecover-
able failure of a multipath capable disk, and requests
MPIO not to support this disk any further. Please check
the status of the multipath capable disk at the array end.
X represents the serial number of the disk.
An unrecoverable failure has
occurred on multipath capable
disk X. This disk will hence-
forth not be accessible.
307
This event is logged when the DSM detects an unrecover-
able failure of a multipath capable disk. Although the disk
may be visible to the system, the data on the disk may
not be accessible. Please check the status of the multipath
capable disk at the array end. X represents the serial
number of the disk.
An unrecoverable failure has
occurred on multipath capable
disk X. The data on this disk
may be inaccessible.
308
— Multipathing driver event log messages40