HP MPIO Full Featured DSM for EVA4x00/6x00/8x00 family of Disk Arrays 4.01.00 installation and reference guide (AA-RW7SP-TE, September 2010)

6. Close the Add/Remove Programs window.
NOTE:
The LUNs may be inaccessible at this time.
7. Reboot the system.
NOTE:
For Windows Server 2008 – Server Core and Microsoft Windows Server 2008 R2 – Server Core,
go to the installation location from the command prompt and run Launch.exe. Select
Remove > Remove all installed components, to remove HP MPIO EVA DSM.
Using silent installation
You can execute the silent installation from the installation location on your computer or from a network
drive. It installs the HP MPIO EVA DSM with little intervention. Silent installation is useful if you are
installing the software on a large number of servers that require software installation.
This section describes the following:
• Installing HP MPIO EVA DSM
• Upgrading HP MPIO EVA DSM
• Removing HP MPIO EVA DSM
• Creating response files for silent mode operations
Syntax:
<install_dir>:\MPInstall\setup.exe /s /f1"C:\setup.iss" /f2"C:\
MPSInstallLog.txt”
The <install_dir> refers to the drive which contains the installation media.
The setup.iss is the response file from which information is taken for silent installation.
The MPSInstallLog.txt file records information about the silent installation.
The ResponseResult section of the MPSInstallLog.txt log file displays the resultant code,
indicating whether or not the silent installation succeeded. An integer value is assigned to the
ResultCode keyname in the ResponseResult section.
Following is the list of common return values along with their descriptions in the ResultCode key:
DescriptionResult Code
Success0
General error–1
Required data not found in the setup.iss file
–3
Not enough memory available–4
File does not exist–5
Installing the HP MPIO Full Featured DSM for EVA4x00/6x00/8x00 family of Disk Arrays12