HP MPIO Full Featured DSM for EVA4x00/6x00/8x00 family of Disk Arrays 4.01.00 installation and reference guide (AA-RW7SP-TE, September 2010)

Cannot write to the response file–6
Unable to write to the log file–7
Invalid path to the InstallShield Silent response (.iss) file
–8
Cannot create the specified folder–51
Cannot access the specified file or folder–52
NOTE:
The C: in /f1C: and /f2C: refers to a local drive on the system or a network drive which is used
to obtain the response file and write the MPSInstallLog.txt (provided the directory has the write
permission enabled).
• For 32 bit systems: <Default_Target_Dir> = C:\Program Files\Hewlett-Packard\HP MPIO DSM\
EVA DSM
• For 64 bit systems: <Default_Target_Dir> = C:\Program Files (x86)\Hewlett-Packard\HP MPIO
DSM\EVA DSM
<User_Target_Dir>= a directory on the system on which the new installation is to be done or
the directory of an existing installation.
You must enclose the paths to the response file and the log file, which records the information about
the silent installation, in quotes ("").
Installing HP MPIO EVA DSM
To perform a silent installation of HP MPIO EVA DSM, complete the following steps:
1. Make a copy of the new.iss file in the installation location with the name setup.iss.
2. Choose one of the following options:
• To install into the default directory for 64 bit systems, in lines 27 and 32 of the setup.iss
file, replace C:\Program Files\Hewlett-Packard\HP MPIO DSM\EVA DSM with C:\Program
Files (x86)\Hewlett-Packard\HP MPIO DSM\EVA DSM.
• To install into the user specified directory for both 32 and 64 bit systems, in lines 27 and 32
of the setup.iss file, replace szDir = <Default_Target_Dir> with szDir =
<User_Target_Dir>.
3. Choose one of the following options:
• To install the Microsoft MPIO Framework component along with the DSM component, use the
renamed default setup.iss file.
• To install only the DSM component (when the Microsoft MPIO Framework already exists on
your system), edit the renamed default setup.iss file as follows:
a. In line 34, replace Component-count=2 with Component-count=1.
b. Remove line 35.
c. In line 36, replace Component-1=DSM with Component-0=DSM.
4. If you want to avoid the automatic reboot feature, edit the setup.iss file as follows:
a. In line 50, replace Result=6 with Result=1.
b. In line 51, replace BootOption=3 with BootOption=0.
HP MPIO Full Featured DSM for EVA4x00/6x00/8x00 family of Disk Arrays 4.01.00 installation
and reference guide 13