HP MPIO Full Featured DSM for EVA4x00/6x00/8x00 family of Disk Arrays 4.01.00 installation and reference guide (AA-RW7SP-TE, September 2010)

DescriptionMessageEvent ID
This event is logged when
generation of removal event
notifications (Event IDs 304, 302
and 108) for the multipath capable
disk with serial number X has been
enabled upon request in the DSM.
The removal event notific-
ations for multipath cap-
able disk X have been en-
abled upon request.
112
This event is logged when the last
path to a multipath capable disk
with serial number X (for which the
generation of removal event
notifications have been disabled) is
disconnected from the system.
The multipath capable disk
X has been disconnected
from the system.
113
The DSM did not initialize success-
fully during startup.
The DSM failed to initial-
ize during startup.
301
All paths to an existing multipath
disk have failed. X represents the
serial number of the disk. Y is the
SCSI address of the last path that
failed.
An unrecoverable path
failure occurred on SCSI
address Y. Disk X failed
due to no redundant paths
available.
302
A new path in excess of the suppor-
ted number of paths for an existing
multipath disk has been discovered.
X represents the serial number of
the disk. Y is the SCSI address of
the newly found path.
Too many paths for disk
with serial number X. Path
(SCSI address Y) not ad-
ded.
303
A redundant path to an existing
multipath disk has failed. X repres-
ents the serial number of the disk.
Y is the SCSI address of the path
that failed.
An unrecoverable path
failure occurred on SCSI
address Y. Disk X is still
accessible over redundant
path(s).
304
The DSM was unable to successfully
throttle I/O activity within the
time-out period, for the specified
multipath disk. X represents the
serial number of the disk.
The DSM timed out on the
I/O throttle operation for
multipath capable disk X.
305
This event is logged when the DSM
detects an unrecoverable failure of
a multipath capable disk, and
requests MPIO not to support this
disk going forward. Please check
the status of the multipath capable
disk at the array end. X represents
the serial number of the disk.
An unrecoverable failure
has occurred on multipath
capable disk X. This disk
will henceforth not be
accessible.
307
HP MPIO Full Featured DSM for EVA4x00/6x00/8x00 family of Disk Arrays 4.01.00 installation
and reference guide 45