manual

1
HQ-CHARGER82
Operating Instruction:
1) Insert the AC power supply cord into mains.
2) For Charging: Switch the function switch on the unit to the "charge"
position.
The individual red LED will light up when batteries are inserted into the
corresponding slot to indicate charging is in progress.
3) For Testing: Switch the function switch on the unit to the "test"
position.
The red LED in the fi rst slot (closest to the function switch) will turn off.
Insert the battery to be tested into the fi rst slot. The battery test lamp
will light up to indicate the strength of the battery (very dark /no light for
no power, very bright for lots of power). Otherwise the LED will not light
up. Batteries in other slots will continue to be charged.
4) For Discharging: Switch the function switch on the unit the "discharge"
position. (Please note that this charger cannot discharge 9V batteries)
All the red LEDs (with the exception for the ones for the 9V batteries)
will go off to indicate batteries are in discharge mode.
5) Please note that this is not an automatic charger. The charger does not
switch to charge mode automatically after discharge. To check if the
batteries are fully discharged, use the "test" feature.
WARNING:
For indoor use only
This charger cannot be used with non-rechargeable batteries.
This a versatile charger that can charge, discharge, and test rechargeable
Ni-Cd batteries.
It can be used with a combination of 1-4 pcs of cells of the following type:
Micro AAA, Mignon AA, Baby C, Mono D. It can also be used to charge 1-2
pcs of Block 9V batteries.
Technical Specifi cation:
Input Voltage: 230 V AC 50 Hz
Charge Current: 120 mA for AAA, C and D size batteries, 13 mA for 9 V
batteries
EN