manual

2
UNIVERSAL Ni-Cd & Ni-Mh BATTERY CHARGER INSTRUCTION
SHEET
BEFORE CHARGING STUDY THE INSTRUCTION SHEET OPERATING
YOUR CHARGER.
A) Slide the SWITCH to charging position
B) Batteries must be inserted properly for good contact and correct (+)
and (-) polarity direction
C) Insert plug into wall outlet
D) "RED LED charging light" goes on to indicate proper charging
E) Do not overcharge your batteries beyond charging periods
recommended for eacht type
TESTING YOUR BATTERIES:
A) Only this slot close to SWITCH can test battery and only also test 12 V
batteries (AAA, AA, C or D cells) higher voltage batteries will burn out
tester bulb.
B) Tester only operates when SWITCH in test position
C) REMEMBER: You fi rst determine if a battery is rechargeable by testing
it. If the "Test indicator" glows weakly, the battery can be charged.
D) When charging period is completed and if the battery indicator does not
light brightly, the "Test indicator" discard it.
DISCHARGING YOUR BATTERIES by Slide SWITCH to discharge
position.
NOTE: Discharging is to eliminate N-Cd battery memory Ni-MH battery
need not discharge.
RED LED does not light during discharging. Judge if battery is discharged
completely by testing it.
Warning: disconnect the supply before making or breaking connections
to the battery: if supply cord is damaged it must be replaced by the
manufacturer or its service agent or a similar qualifi ed person in order to
avoid a hazard:
"Do not charge non-rechargeable batteries"