Datasheet

02/2020 Profi pack P 425 15
english
7 Troubleshooting
Fault Possible
cause
Remedy
Continuous
lamp
Cardboard
too thick
►Press “Reverse” button.
The cutting unit
runs in reverse and pushes the cardboard
backwards.
Machine
does not start
Overloading ►Switching the machine off
Allow the Profi pack to cool for 20–30 minutes before
restarting.
Other faults If problem persists
►Contact HSM Service.
For our customer service addresses see page 192.
8 Cleaning
Switch off the machine and disconnect the power plug. When cleaning, only use a soft cloth
and a mild soap-water solution. However, no water must enter the equipment.
9 Disposal / recycling
Dispose of the machine in an environmentally sound way at the end of its service
life. Observe the current regulations when doing this. As legislation is subject to
ongoing changes, we request that you contact your local authorities at the ap-
propriate time. As the manufacturer, HSM would be pleased to advise you on the
disposal of your old machine.