Installation & Assembly

42776
ASSEMBLY & INSTALLATION INSTRUCTIONS
HF Reflections — Vessel Sconces 202140, 202143 & 202145
B398
To Install Fixture (Figure 1, following page, single sconce used for illustration)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
3 OF 4
1. Carefully unpack the xture (A) from the carton.
2. Unscrew at head screws (C) from mounting bracket (B) and separate bracket from xture.
3. Place the mounting bracket (B) over the electrical box being sure to hold it level. Line up holes in mounting bracket
with holes in electrical box. Attach mounting bracket with pan head screws (D).
4. Hold xture (A) close to wall. Using suitable wire connectors (not provided), connect xture wires to supply wires
(white to white and black to black). Connect all ground wires (bare copper or green to bare copper or green).
5. Place xture (A) over mounting bracket (B). Secure with at head screws (C) on top and bottom of xture. Be sure
no wires are pinched between xture and wall.
6. Install bulb (F) (not included) into socket
7. Unpack glass (G). Loosen thumb screws (E) in xture.
Note: Thumb screws do not need to be removed completely.
8. Slide glass (G) over bulb (F) and align holes in glass with thumb screws (E).
9. Screw thumb screws through holes to hold glass.
10. Repeat if installing multi-light xture.
11. Restore electricity at main breaker.
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON SECURELY, AND NO BARE WIRE IS EXPOSED.
Care Instructions
To clean your xture, use a soft, non-abrasive cloth with water and a mild detergent soap. Be sure to rotate the cloth so
you’re always using clean sections of it. For extra protection, follow cleaning with a non-abrasive paste or liquid wax.
Always use a soft, non-abrasive cloth for application.
DO NOT use abrasive materials or cleaners or any products with alcohol or ammonia (most common cleaners such as
Windex, Endust, etc. contain chemicals that will damage the nish).