Installation Instructions

8
1886
Assembling the LIght Kit
Partially install two light kit screws, found in
the
hardware bag, halfway into the motor
housing as shown. It does not matter which
two screw holes you choose.
Feed the 9-pin plug connector coming from
the bottom of the motor housing through
the center hole in the light kit assembly.
Align the keyhole slots in the top of the light
kit assembly with the partially installed
screws. Wrap the keyhole slots around the
screws and twist counterclockwise.
Connect it to the plug connector found in the switch
housing area of the light kit assembly. Make sure to
line up the colored markings on the connectors.
Align the the screw holes in the upper switch
housing posts with the holes in the lower
switch housing. Raise the switch housing to
the upper switchhousing
Install the three xture screws. Tighten all
three screws securely.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 3
Light Kit Screw
BAG
1 of 3
3 of 3
BAG
Insert the third screw, found in the
hardware bag, in place and rmly
tighten all the three screws.
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulb Pull Chain
Light Kit Screw
Fixture Screws
Note: The screws were installed for
shipping purposes only.
Repeat x2
Remove the pre-installed xture screws
from the light kit assembly. Save the
screws. It will be needed for light kit
installation.
Preparing the Light Fixture
Follow these steps to prepare the light xture for installation.
KEEP
x3
Fixture Screw
Remove and discard the plastic
connectors from the ends of the two
pull chains.
Carefully remove the light kit assembly
from the light xture hood and set the
light xture aside.
These are the screws you saved
that were installed.