Installation Instructions

9
1886
Keyhole
Slot
Installing the Light Fixture
3 of 3
Light Kit
Assembly Screw
BAG
Partially install light kit assembly screws,
found in the hardware bag, into the posts
as shown, leaving the circled post empty.
Light Kit Assembly
Screw
Empty Post
Connect the plugs from the upper
and lower switch housings. Make
sure to line up the colored markings
on the connectors and that the
connectors latch.
Align the three keyhole slots in the light
kit hood with the three assembly screws
in the posts. Lift the light kit assembly
and twist counterclockwise to lock it
into place.
Install a bulb into the
socket. When necessary,
replace with bulbs of
the same wattage.
Install the saved light kit
screw and tighten all four
screws securely.
This is the screw you saved that
was attached to the red ag.
Light Kit Screw
1 of 1
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs/Cage Remote Cradle
Fan style may vary.
Note:
Fan style may vary.
Note:
WARNING
FAN FALL HAZARD
Make sure screws are tight to secure the
light xture.