Total Air Purification HEPA Air Purifier Owner’s Manual English Model 30847 Form# 44030-01 20100119 ©2010 Hunter Fan Co.
Table of Contents Introduction ������������������������������������������������������������� 3 Safety Instructions ����������������������������������������������������� 3 Setting Up Your Air Purifier ��������������������������������������� 5 How The System Works �������������������������������������������� 6 Operating Your Air Purifier ��������������������������������������� 7 Air Purifier Maintenance ������������������������������������������� 7 Check or Clean Your Pre-Filter Check or Replace Your Filters
Introduction Thank you for purchasing the Total Air Purification System from Hunter Fan Company. You have purchased our latest development in Portable Air Purification Systems. This system has been developed to improve the quality of the air you breathe. Our HEPA Air Purification System out performs other air purification systems by quickly and effectively removing dust, smoke, and pollen particles as small as 0.3 microns in size. The following innovative features are included in your Hunter Air Purifier.
3. This Air Purifier is designed for use on a level floor and may not work properly on an uneven floor. ALWAYS place the Air Purifier on a firm, level floor. ALWAYS place the Air Purifier at least six (6) inches away from walls and heat sources such as stoves, radiators, or heaters. 4. Place the Air Purifier in an area that is out of the reach of children. 5. Before using the Air Purifier, extend the cord and inspect for any signs of damage. DO NOT use the product if the cord has been damaged. 6.
Setting Up Your Air Purifier 1. Take the Air Purifier out of the box and remove the clear plastic protective bag and place the unit on a firm, level surface. 2. Before turning on the Air Purifier, you need to confirm that the filters are firmly in place and have not become loose during shipping. To check the filters, push down on the tab under the handle. Figure 1. 3. Gently pull the rear grill away from the unit and lift away. Figure 2. Tab Figure 1. 4.
How The System Works Dust and other irritants are pulled into the Air Purifier by the fan. The Washable Pre-Filter attracts larger particles like pet dander and hair and traps them on the Pre-Filter. Smaller particles such as dust, mold, and pollen pass through the Pre-Filter and are captured by the HEPA filters. Up to 99.9% of particles can be captured. The UVC Light helps kill particles not trapped on the HEPA Filters and the Photocatalytic Oxidation screen removes harmful VOC’s.
Operating Your Air Purifier OFF UVC ON/OFF UVC Indicator Unit off Low speed - Recommended for use when soft background noise is unwanted. Medium speed - Typical usage setting. Soft background noise is not an issue. High speed - Use when quick, efficient results to a room’s air quality are desired. Speed control ON/OFF ON/OFF Indicator Figure 6. The fan speed can be adjusted at any time by rotating the dial so the indicator light aligns with the desired speed.
5. If the Pre-Filter needs to be cleaned, It may be submerged in warm soapy water to clean. Gently lift and submerge the filter several times to clean. 6. When complete, rinse the filter with warm water and allow to dry completely. Note: Wet parts placed into the unit can cause damage to the filters and or the motor of the Air Purifier. Check or Replace Your Filters 1. Turn the Air Purifier off and disconnect from the wall. 2.
Note: Oils from your skin can cause damage to the bulb and will prevent it from working. 7. Using the bag the bulb came in to prevent skin contact with the bulb, insert the base of the bulb into the lower UVC socket in the unit, with the flat side of the base facing the opening of the unit. Figure 13. 8. Insert the top part of the UVC bulb into the top socket and roll the bulb to the right util it locks into place. Note: If the UVC Bulb Guard is not re-installed correctly, the unit will not run. Figure 12.
Troubleshooting Problem: No Operation. Solution: 33Confirm that the unit is plugged in. 33Check the installation of the Rear grill. 33Check the installation of the UVC Lamp Cover. Problem: Unit has reduced air flow or increased noise. Solution: 33 The filter may be clogged and needs to be cleaned. See “Check or Replace Your Filter” on page 10. Problem: The UVC Lamp is not operating. Solution: 33Check the installation of the UVC Bulb. 33Replace the UVC Bulb. See “Replace The UVC Bulb” on page 8.
Filter Ordering Products Depending on usage and the environment, your Hepa filter should be replaced once a year. Replacement filters are available at most retailers that carry Hunter Air Purifiers. You may also purchase directly from Hunter Fan Company by: Phone: 1-888-354-8375 Website: www.hunterfan.com Ceiling Fans Humidifiers * Applicable state and local taxes may apply. * Prices are subject to change without notice.
y nt ra ar W IF THE ORIGINAL RESIDENTIAL USER OR CONSUMER PURCHASER CEASES TO OWN THE AIR PURIFIER, THIS WARRANTY AND ANY IMPLIED WARRANTY WHICH THEN REMAINS IN EFFECT, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE VOIDED. NO WARRANTY, EXPRESSED OR IMPLIED, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS MADE IN RESPECT TO THE FILTER MATERIAL OR WASHABLE FILTER.
y SOME AMERICAN STATES AND CANADIAN PROVINCES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF DIRECT, INDIRECT SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. SOME AMERICAN STATES AND CANADIAN PROVINCES DO NOT ALLOW THE EXCLUSION OR INVALIDITY OF EXPRESS OR IMPLIED WARRANTIES IF THE USER CEASES TO OWN THE AIR PURIFIER, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
Filter and UVC Calendar Notes Date of Replacement or Cleaning Pre-Filter HEPA Filters UVC Bulb Printed in china and Taiwan ©2010 Hunter Fan Co.
