Full Product Manual

INSTALLATION
BLADES
7
A
A
Line up the pin on the post with
the opening on the blade holder.
B
Using our quick connect system,
insert the blade tube into the
blade hub. The blade will click into
place at the correct pre-set angle.
C
Use a torque wrench to tighten
the two set screws to 20 ft. lbs
(240 in. lbs.)
D
Repeat steps A-C for each of the
four remaining blades.
B
C
NOTE
The blade end is marked with a number to signify
which size fan it goes with. Make sure you match
the correct blade size with the correct motor size.
14