SINCE 1886 R USE AND CARE GUIDE CORY 2 LIGHT FLUSH MOUNT -#M99197
TOOLS REQUIRED Safety goggles Phillips screwdriver Flathead screwdriver Wire strippers Wire cutters Ladder Pliers Electrical tape NOTE: This item requires the use of one 120V, 60Hz, 60-Watt antique bulb (included) or one 120V, 60Hz, 60-Watt max, medium-base type A bulb (not included). Do not exceed the recommended wattage. HARDWARE INCLUDED NOTE: Hardware not shown to actual size.
Installation instructions 1. Installing the mounting plate CAUTION: Ensure the power is off at the main fuse box prior to beginning installation . □ Turn off the switch at the wall. □ Turn the power off at the main fuse box. □ Attach the mounting plate (BB) to the outlet box using the outlet box screws (CC). 2. Connecting the wires □ Install the fixture bare copper wire (1) under the ground screw (EE) on the mounting plate (BB).
Installation instructions (continued) 3. Installing the fixture 4. Installing the bulbs □ Push all excess wires into the outlet box. □ Raise the fixture to the ceiling and secure the canopy (A) in place with finials (GG). □ Prior to installing the bulbs, please inspect sockets for silica packet, if packet is present, remove and throw away, do not expose to children and pets. □ Install two 120V, 60Hz, 60-Watt antique bulbs (B) (included) or two 120V, 60Hz, 60-Watt max.
