Installation Guide

1886

Ceiling Bracket Top housing Hanging Fan Wiring Canopy Blades Light Glass/Bulbs

Installing the Canopy

Installing the Blades

2 of 3

Canopy

Screws

bag

1 of 3

Canopy

Screws

bag

Swing the fan up to align the

canopy screw holes with the

mounting holes on the ceiling plate.

Using both hands, push the canopy trim

ring up to the top of the canopy. The canopy

trim ring will snap and lock into place.

Hold the canopy up with the screw holes

aligned. Partially install two canopy screws,

found in the hardware bag, into the

holes opposite the ceiling plate hooks.

Partially install a canopy screw, found

in the hardware bag, between

the ceiling plate hooks. When all the

holes are properly aligned, securely

tighten all three canopy screws.

Note: The slots in the canopy must

remain engaged while swinging the

canopy for alignment.

Note: Should you need to remove the trim ring,

press rmly on opposite sides of the trim ring. The

tabs will ex out releasing the canopy trim ring.

Repeat x4

Put the blade washers, found in the hardware bag, onto the

blade screws, found in the hardware bag. Then install the blade

screws to secure each blade to a blade iron.

x12

bag

Blade Screw

Washer

Fan style may vary.

Note:

Fan style may vary.

Note: