User's Manual

The ICR transmitter requires 4 AA alkaline batteries. To

install the batteries. remove the two screws holding the

battery on the back of the transmitter. Drop the batteries

into the battery compartment and replace the door. Your

transmitter is now ready to operate.

with the current Run Time is displayed. (default is 10

minutes) The Run Time will be blinking at this point.

If more than 5 seconds go by

without a button being pressed,

the Transmitter will revert back to

displaying the active station.

3. Use the

or buttons to

change the Run Time to any of

the 8 settings ranging from 1 to

90 minutes. Then do not touch any of the buttons for

5 seconds and the display will stop blinking and return

back to the active station.

INSTALLING THE TRANSMITTER BATTERIES ............................................

CHANGING THE RUN TIME ..............................................................................

You have the ability to adjust the amount of time that a

station will run once it has been turned on by your ICR.

This does not affect the run time programmed into your

controller. This adjustment is made at the transmitter as

described below.

To change the Run Time:

1. If the unit is OFF (no display), power the transmitter by

pressing any of the buttons for at least 1 second then

releasing the button. The transmitter will illuminate and

display the active station.

2. Press the Mode button until the words “Run Time” along

36/5*.&