User's Manual

Both the ICR Transmitter and Receiver have an “address”

that they use when communicating. If the addresses do

not match, the Receiver will ignore the transmission. Your

ICR comes from the factory with both the transmitter and

Receiver address set to 0. You may change the address to

any value from 0-127 for added security. Note that if you

change the Transmitter address, the Receiver must “learn”

the new address as described in the “Preparing the Receiver

for Use” section.

To change the Transmitter address:

1. If the unit is OFF (no display), power the Transmitter up

by pressing any of the buttons for at least 1 second then

releasing the button. The Transmitter will illuminate the

active station.

2. Press the Mode button until the word “Address” appears

on the display. The address will be blinking at this point.

If more than 5 seconds go by

without a button being pressed,

the Transmitter will revert back to

displaying the active station.

3. Use the

or button to

change the address to any value

between 0 and 127. Then do not

touch any of the buttons for 5 seconds and the display

will stop blinking and return back to the active station.

Your ICR Transmitter comes from the factory with the

maximum number of stations set to 9. This means that when

you use the

or buttons to change the station, you

may change it to any number between 1 and 9. However, if

you have controllers with more than 9 stations you will want

to increase the maximum number of stations.

CHANGING THE TRANSMITTER ADDRESS ..................................................

To change the Maximum Number of Stations:

1. If the unit is OFF (no display), power the Transmitter up

by pressing any of the buttons for at least 1 second then

releasing the button. The Transmitter will illuminate the

active station.

CHANGING THE MAXIMUM NUMBER OF STATIONS .................................

"%%3&44