User's Manual

To remotely activate a station or program:

1. Plug your Receiver into an active SmartPort

wiring

harness (one attached to a powered controller) and wait

for 2 beeps indicating the Receiver is ready.

2. If your Transmitter is not on (no display), press any

button for at least 1 second and release. The Transmitter

will display the active station.

3. Use the

or buttons to display the station or

program (A,B, or C) you would

like to start.

4. Momentarily press the “ON”

button to start the station or

program. The Transmitter will

display the word “TRANSMIT”

and will flash for about 4 seconds indicating that it is

sending the command to the Receiver. If you are near the

Receiver, you will hear it beep 2 times, indicating that it

has received the command.

5. Press the “OFF” button at any time to turn off the station

or program. The display will again read “TRANSMIT” and

flash, and the Receiver will again beep twice. The ICR

is designed to turn one station on at a time. Therefore,

turning a station on while another is already on will

cause the first station to turn off.

6. If one of the programs (A,B, C or P1 through P18)

is selected, all stations in the selected program will

run sequentially for the run time programmed in the

controller.

ACTIVATING A STATION WITH THE ICR REMOTE SYSTEM ......................

2. After the Receiver starts to beep, release the button.

3. Press either the “ON” or “OFF” button on your transmit

ter.

4. The Receiver will beep 4 additional times indicating

that it has learned the new Transmitter address and will

respond only to it from this point on.

The ICR system will allow you to remotely turn on and off

any station on your Hunter controller with the press of a

button. Once on, the station will run for the run time you

have designated in the ICR transmitter.

45"5*0/