User's Manual

To utilize the ICR remote control system, your controller

must be equipped with a SmartPort wiring harness. This

wiring harness provides the communication port where the

ICR receiver is attached. The SmartPort can be connected to

Hunter SRC, Pro-C and ICC controllers. A SmartPort wiring

harness is provided with your ICR remote system. The

typical SmartPort location is approximately 12" below the

controller. The recommended installation procedure for this

location would be as follows:

SmartPort

WIRING HARNESS .......................................................................

INSTALLING THE SmartPort

WIRING HARNESS ........................................

1. Install a ½" female threaded “Tee” in the field wiring

conduit approximately 12" below the controller.

2. Feed the red, white, and blue wires of the SmartPort

through the base of the “Tee” and into the controller

wiring compartment as shown in the following figures.

NOTE: The harness may be installed outdoors

by bringing the conduit through an exterior

wall, then installing the appropriate fitting.

NOTE: For installations where the receiver

will be installed permanently on an outside

wall, make certain that the SmartPort is the

version with an o-ring seal.

/2" Thread

To Controller

Pre-assembled Assembled