Use and Care Manual

6. Insert the power adapter into the
bottom right side of the unit, then plug
the adapter into a wall outlet. (Figure 4)
Personal UltrasonicPersonal UltrasonicPersonal Ultrasonic
Model
XJ-520
READ AND SAVE THESE INSTRUCTIONS!
•
reach of children.
•
for any signs of damage. DO NOT use the product if the
cord has been damaged.
•
not in operation or while it is being cleaned.
• This product is intended for residential use only. DO
NOT use outdoors.
Transducer
Top cap
Fan Exhaust
Base
Bottle Cap
Power Adapter
Control Panel
Mist Exhaust
Reservoir
Cover
Initial Setup:
1. Unravel and straighten the cord before use.
Set the unit on a at, waterproof surface.
2.
4. Use the bottle cap that came with your humidier and
screw it onto the mouth of the water bottle rmly.
3. Remove the top cap from the reservoir cover. Place the
reservoir cover back onto the base.
(Figure 1)
5. Turn your water bottle upside down and insert into the
water reservoir. (Figure 3)
Note: Failure to ensure the water bottle is seated correctly
could cause the unit to leak water from the tank.
Operation:
1. To turn the humidier ON, press the "MIST" button. This
will adjust the mist output to High, Medium, Low and Off.
The indicator lights on the control panel will indicate the
humidity level selected.
2. To turn the humidier OFF, pressing the "Mist" button until
the indicator lights turn off.
3. To turn the color changing LED light on, press the "LIGHT"
button. Press the button again at the
desired light color to set to that color.
To turn the LED light off, pressing the
"LIGHT" button until the light turn off.
(Figure 5)
Maintenance:
1.
2.
3.
4.
Turn off the humidier and unplug the power adapter
from the wall and the unit.
Remove the water bottle from the unit and remove the
bottle cap.
Empty the water from the bottle.
Rinse the bottle cap thoroughly with warm water.
Replace the water bottle if necessary.
Remove the reservoir cover from the humidier and
empty any remaining water.
Wipe any mineral deposits from the cover and base
with a soft cloth.
Replace the cover onto the base. Align
notch on the cover with the groove on
the base. The mist exhaust should be 45
to the left of the control panel. (Figure 6)
5.
6.
7.
• DO NOT use water bottles greater than 22oz.
20307-01 20160730
Figure 1 Figure 3Figure 2
Figure 4
Figure 6
Figure 5
LIGHT button
MIST button
Lo Mi Hi
LIGHT
MIST
Lo
Mi
Hi
(Figure 2)
o