User Guide

09031
2 SIDED
Rev: 0
CHEVROLET/GMC SILVERADO/SIERRA CREW CAB – PART NO. 09031
INSTALLATION INSTRUCTIONS
Congratulations on your purchase of the Husky Gear Box. The Gear Box was designed to fit under the rear seat of your truck. The
Gear Box gives you a place to store loose items and clutter and ultimately help keep your vehicle organized. It’s designed to fit your
vehicle with or without your Husky Liners in place and only takes a few minutes to install.
PACKAGE CONTENTS
Gear Box – Part No: 09031 (1)
Safety Straps with Strap Locks (1)
Dividers (2)
Installation Instructions (1)
INSTRUCTIONS
1) Open and remove the Gear Box from the shipping box and protective plastic bag.
2) Install the safety strap into slot located on the back wall of the Gear Box (Figure 1 and 2). The strap lock should be
upright with the hinge facing away from the Gear Box.
Figure 1 Figure 2
3) Lift the rear seats into the upright position and install the Gear Box. The safety straps should be facing towards rear of
your vehicle.
4) Install the safety strap through the hole in the passenger side metal seat bracket (Figure 3 and 4). Feed the strap
through the strap lock and fasten. Pull on the strap to make sure the strap and the strap lock has been properly
fastened.