Troubleshooting Guide

3 TON SUPER LOW SUPER HIGH

GARAGE JACK

Maintenance

REPLACING HYDRAULIC JACK OIL TO THE JACK

OIL PAN

NOTE: When draining oil, use a proper container and

always follow all local and state waste disposal guidelines.

Open the release valve by turning the handle

counterclockwise.

Opening the release valve

Remove the oil ll plug.

Removing the plug

Turn the entire jack over so that all of the old

oil will drain out of the oil ll hole.

Draining the old oil

After all of the old oil has drained out of the

jack, turn the jack back over to a level position.

Leveling the jack

PAGE 1
3 TON SUPER LOW SUPER HIGH GARAGE JACK Maintenance REPLACING HYDRAULIC JACK OIL TO THE JACK 1 Opening the release valve 2 Removing the plug 3 Draining the old oil 4 Leveling the jack Open the release valve by turning the handle counterclockwise. Turn the entire jack over so that all of the old oil will drain out of the oil fill hole. Remove the oil fill plug. After all of the old oil has drained out of the jack, turn the jack back over to a level position.
PAGE 2
5 Releasing pressurized air Rapidly pump the jack handle 6 to 8 strokes to release any pressurized air. 6 Filling with new oil Using a good grade of SAE 5W hydraulic jack oil, fill the reservoir to the bottom of the threads in the oil fill hole. Replace and tighten the oil fill plug. Do not allow dirt and debris to enter the system. Lubricating the jack Use a good grade of lubricating oil on all moving parts when needed (arm linkages, front wheels and rear casters).
PAGE 3
Care and Cleaning Maintain the product according to these instructions. You may not alter this product in any way. 1. Before using, inspect the jack thoroughly. Look for cracks in the welds, bent, damaged, loose, worn or missing parts. 2. Inspect according to this manual ONLY. 3. If the jack has been subjected to abnormal load or shock (abuse), perform an immediate inspection. Take the product to a local customer service representative for an authorized inspection before use.