User's Manual

English – 13

ASSEMBLY

Fitting the guard extension

143R

CAUTION! The guard extension shall always be ﬁtted when

using the trimmer head/plastic blades and combination

guard. The guard extension shall always be removed when

using the grass blade and combination guard.

Enter the guard extension guide in the slot of the combination

guard. Then click the guard extension into position on the

guard with the four quick-fasteners.

The guard extension is removed easily using the spark plug

spanner, see illustration.

Fitting the transport guard

1 Insert the tips of the blade into the grooves in the transport

guard (A).

2 Wind the transport guard around the teeth of the blade,

then clip the ends together (B).

Fitting a blade guard, grass blade

and grass cutter

• 132R: The blade guard (A) is ﬁtted using 4 screws (L) as

shown. CAUTION! Use the recommended blade guard.

See the Technical data section.

133R: Hook the blade guard/combination guard (A) onto

the ﬁtting on the shaft and secure with the bolt (L).

142R: Fit the guard (A) to the gear housing using the

support plate (M) and two screws (L).

CAUTION! Ensure that the guard extension is removed.

Use the recommended blade guard. See the Technical

data section.

143R: Hook the blade guard/combination guard (A) onto

the ﬁtting on the shaft and secure with the bolt. CAUTION!

Ensure that the guard extension is removed. Use the

recommended blade guard. See the Technical data

section.

• Fit the drive disc (B) on the output shaft.

• Turn the blade shaft until one of the holes in the drive disc

aligns with the corresponding hole in the gear housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• Place the blade (D), support cup (E) and support ﬂange

(F) on the output shaft.

A B