CR3HTO-HTB Hot Counter-Top Service Case INSTALLATION & OPERATION GUIDE Hot Top w/ Self Service Heat or Refrig. CR3HTO-HTB /Chino Rev.
IGFC-CR3H-HTB-1104 General Instructions Table of Contents THIS BOOKLET CONTAINS INFORMATION ON: General Instructions ................................................ 2 Case Drawings ......................................................... 3 NSF Installation Note ............................................. 3 LEVELING.............................................................................................................. 4 Electrical .................................................................
Rev.
IGFC-CR3H-HTB-1104 L O C AT I O N LEVELING IMPORTANT! It is imperative that cases and supporting counters be leveled from front to back and side to side prior to joining. A level case is necessary to insure proper operation, water drainage, and plexiglass alignment. The merchandisers have been designed for use only in air conditioned stores where temperature and humidity are maintained at or below 75°F and 55% relative humidity. DO NOT allow air conditioning, electric fans, open doors or windows (etc.
Rev.1104 ANTISTATIC COATINGS are not intended nor suitable for large motors or other external appliances. The 210® has proven to be very effective in not only cleaning and polishing the Plexiglass surface, but also providing antistatic and anti-fog capabilities. This product also seals pores and provides a protective coating. BEFORE SERVICING Always disconnect Electrical Power at the Main Disconnect when servicing or replacing any electrical component.
IGFC-CR3H-HTB-1104 3. Finally, raise the glass to it's full extension. This should release any settled lubricant in the cylinders, and prevent any stress on the front glass. After the case is brought to operating temperature the first time, recheck the Allen screws on the glass once the case once the case is in full operation and brought to temperature. dust, grease, oil, and fingerprints without the need for cleaning fluids.
Rev.1104 as fried chicken but this is not necessarily true. ALL foods will continue to be affected by prolonged exposure to elevated temperatures. otherwise indicated. REPLACING FLUORESCENT LAMPS Fluorescent lamps are furnished with a shatterproof protective coating. The same type of lamp with protective coating must be used if replaced. The following guidelines are provided only as a general guide for the use of this equipment.
IGFC-CR3H-HTB-1104 * If practical, the food should be covered during slack sale periods to reduce dehydration. * At end of the day, remove product and let case cool. Then clean with soap and water (use oven cleaner on the difficult spots). Polish and clean glass with a good glass cleaner. Case Startup CONTROLS The controls are located at the rear of the case. Timer Panel Locaton Control Panel Locaton Parts of the case exterior, shelves and light bulbs become extremely hot when in use.
Rev.1104 Timer Operation ©FAST key Numbered product keys above correspond to FC4H-Cinnabon pans 1-7 below Numbered product keys above correspond to FC3H-Cinnabon pans 1-4 below 2 3 7 2 4 1 4 5 6 1 3 (back of case) (back of case) NOTE: The colon will flash if the unit is in hours / minutes mode and be on constant in minutes / seconds mode. • To enter programming from '--:--', press the ©(FAST.) key for three seconds. The display will change to "PROG".
L1 L2 L3 L1 L2 L3 6.7 0.0 0.0 0.0 0.0 HUSSMA NN® CORPORATION 13770 RAMONA AVENUE CHINO, CA.917 10 (90 9) 590-4 910 LIC.
HUSSMA NN® CORPORATION 13770 RAMONA AVENUE CHINO, CA.917 10 (90 9) 590-4 910 LIC.#: 644 406 NOTE: CASE MUST BE GROUNDED 115 V LOADING L1 8.2 L2 0.0 L3 0.0 L1 0.0 L2 0.0 L3 0.
L1 4.1 L2 4.1 L3 L1 L2 L3 HUSSMA NN® CORPORATION 13770 RAMONA AVENUE CHINO, CA.917 10 (90 9) 590-4 910 LIC.
L1 L2 L3 L1 L2 L3 11.7 0.0 0.0 0.0 0.0 0.0 HUSSMA NN® CORPORATION 13770 RAMONA AVENUE CHINO, CA.917 10 (90 9) 59 0-4 910 LIC.
IGFC-CR3H-HTB-1104 11. When transferring hot foods in the heated merchandiser to clean pans, preheat the clean pan. Transferring hot foods to room temperature pans can cause the temperature of the food to drop 20° or more thus causing food to be at an unsafe serving temperature. 12. Clean spills as they happen simply by wiping with a cloth. Be sure to use a dry cloth on very hot surfaces to prevent steam burns. 13. Turn the equipment off and allow to cool before cleaning. 14.
HUSSMANN® CORPORATION 13770 RAMONA AVENUE CHINO, CA.91710 (909) 590-4910 LIC.#: 644406 NOTE: CASE MUST BE GROUNDED 115 V LOADING L1 11.7 L2 0.0 L3 0.0 L1 0.0 L2 0.0 L3 0.
IGFC-CR3H-HTB-1104 operation. When units are empty, they experience rapid rise of heated air from air outside the case. This action gives empty units a false, lower than desired, temperature reading. Loading the case traps the air at the griddle, raising temperatures to the 165°F to 185°F range, keeping product well above the FDA guidelines. Remember, these units must be loaded with product to maintain safe product temperature. 5.
Warranty Rev.1104 Limited Warranty This warranty is made to the original user at the original installation site and is not transferable. Hussmann merchandisers are warranted to be free from defect in material and workmanship under normal use and service for a period of one (1) year from the date of original installation (not to exceed fifteen (15) months from the date of shipment for the factory). Hussmann Impact Modular Coils are warranted for a total of five (5) years based upon the above criteria.
IGFC-CR3H-HTB-1104 Service Record Last service date: By: /Chino The MODEL NAME and SERIAL NUMBER is required in order to provide you with the correct parts and information for your particular unit. Additional copies of thispublication may be obtained by contacting: Hussmann® Chino They can be found on a small metal plate on the unit. Please note them below for future reference.