Corp. Refrigerator User Manual

ManualsBrandshussman ManualsRefrigeratorhussman Corp. Refrigerator IGFP-R3

IGFP-R3, R3P-0608

BEFORE SERVICING

ALWAYS DISCONNECT ELECTRICAL

POWER AT THE MAIN DISCONNECT

WHEN SERVICING OR REPLACING ANY

ELECTRICAL COMPONENT.

This includes (but not limited to) Fans, Heaters

Thermostats, and Lights.

Field Wiring and Serial Plate Amperage

Field Wiring must be sized for component amperes printed

on the serial plate. Actual ampere draw may be less than

specied. Field wiring from the refrigeration control panel to

the merchandisers is required for refrigeration thermostats.

Most component amperes are listed in the “Case Specs”

section, but always check the serial plate.

Ballast Location

Ballasts are located within the access panel that runs the

length of the rear of the case.

User Information

Stocking

Improper temperature and lighting will cause serious

product loss. Discoloration, dehydration and spoilage

can be controlled with proper use of the equipment and

handling of product. Product temperature should always

be maintained at a constant and proper temperature.

This means that from the time the product is received,

through storage, preparation and display, the temperature

of the product must be controlled to maximize life of the

product. Hussmann cases were not designed to “heat up”

or “cool down” product - but rather to maintain an item’s

proper temperature for maximum shelf life. To achieve the

protection required always:

1. Minimize processing time to avoid damaging

temperature rise to the product. Product should be

at proper temperature.

2. Keep the air in and around the case area free

of foreign gasses and fumes or food will rapidly

deteriorate.

3. Maintain the display merchandisers temperature

controls as outlined in the refrigerator section of this

manual.

4. Do not place any product into these refrigerators

until all controls have been adjusted and they

are operating at the proper temperature. Allow

merchandiser to operate a minimum of 6 hours

before stocking with any product.

5. When stocking, never allow the product to extend

beyond the recommended load limit. Air discharge

and return air ow must be unobstructed at all

times to provide proper refrigeration.

6. Keep the service doors closed (when applicable).

Refrigeration performance will be seriously affected

if left open for a prolonged period of time.

7. Avoid the use of supplemental ood or spot lighting.

Display light intensity has been designed for

maximum visibility and product life at the factory.

The use of higher output uorescent lamps (H.O.

and V.H.O.), will shorten the shelf life of the product.

FOR PROMPT SERVICE

When Contacting the Factory regarding problems.

Be sure to have the Case MODEL and

SERIAL NUMBER Handy. This Information

is on a plate located on the case itself.

Cleaning Glass and Mirrors

Only use a soft cloth and mild glass cleaning for cleaning

any glass or mirrored components. Be sure to rinse and/or

dry completely.

Never use hot water on cold glass surfaces! It may

shatter and cause serious injury! Allow glass surfaces

to warm rst.

Replacing Fluorescent Lamps

Fluorescent lamps are furnished with a shatterproof

protective coating. The same type of lamp with protective

coating must be used if replaced.

ENCAPSULITE

SHATTERPROOF COATING - SA 10645

Complies with FDA USDA

& OSHA Regulations

for replacement call:

1-800-395-9229

Turn switch off then on after replacing bulb

NSF

Electrical (Cont'd)