Corp. Refrigerator User Manual

Rev.0303
9
User Information
Joint Trim
ESSS Only
(ESS dows not have joint trim)
CAMLOCK
&
SEALANT
LOCATIONS
CAMLOCK
ACCESS
PANEL
APPLY SEALANT
TO SHADED AREA
JOINT BACKER
LOCATION
CAMLOCK
LOCATIONS
SEAL AROUND PIPING
ACCESS HOLES
BOLT INSIDE
WEDGES
CAMLOCK
LOCATION
STOCKING
Improper temperature and lighting will cause serious prod-
uct loss. Discoloration, dehydration and spoilage can be
controlled with proper use of the equipment and handling
of product. Product temperature should always be main-
tained at a constant and proper temperature. This means
that from the time the product is received, through stor-
age, preparation and display, the temperature of the prod-
uct must be controlled to maximize life of the product.
Hussmann cases were not designed to “heat up” or “cool
down” product—but rather to maintain an item’s proper
temperature for maximum shelf life. To achieve the pro-
tection required always:
1. Minimize processing time to avoid damaging tem-
perature rise to the product. Product should be at
proper temperature.
2. Keep the air in and around the case area free of
foreign gasses and fumes or food will rapidly dete-
riorate.
3. Maintain the display merchandisers temperature
controls as outlined in the refrigerator section of
this manual.
4. Do not place any product into these refrigerators
until all controls have been adjusted and they are
operating at the proper temperature. Allow mer-
chandiser to operate a minimum of 6 hours before
stocking with any product.
5. When stocking, never allow the product to extend
beyond the recommended load limit. Air dis-
charge and return air flue must be unob-
structed at all times to provide proper refrig-
eration.
6. There are vents located at the base of the front of
the glass, just above the front rail. These vents supply
a continuous, gentle flow of air across the front glass
which inhibits condensation. Do not place any
signs or other restrictive objects on the front
of the refrigerator that will block these vents.
7. Keep the service doors closed (when applicable).
Refrigeration performance will be seriously affected
if left open for a prolonged period of time.
8. Avoid the use of supplemental flood or spot lighting.
Display light intensity has been designed for maxi-
mum visibility and product life at the factory. The use
of higher output fluorescent lamps (H.O. and V.H.O.),
will shorten the shelf life of the product.
9. In the Deli, Meat and Fish cases, completely cover
the product each night with a clean damp cloth or
butcher paper (never use plastic, as it does not allow
for proper circulation). Make sure the cloth or paper
is in direct contact with the product.
10.Turn and rotate the meat fairly often. The blood
which gives the pink color works its way downward
with time.
11.Cold coils remove heat and moisture from the case
and deposit this as frost onto the coil. Thus, a
defrost is required. Our humidity system induces
moisture into the case and helps slow down the