User Manual HWAM® SmartControl™ Generation 2

10
E
6
8
9
7
E
Standby
The phase indicator shows that the system is in
standby mode. This means that the system has
been in use, and that the temperature in the
stove is now so low that it cannot be guaranteed
that the stove can light new wood. It is therefore
necessary start anew if you want to burn more
wood.
6
Stoking time
The stoking time shows the estimated time to the next
stoking. The stoking time will only be estimated when
the system reaches the ember phase. If there is a big
dierence between actual and desired room tempera-
ture, the restoking alarm comes on, even though there
is unburned wood and flames.
Flue gas temperature
Displays the measured flue gas temperature. The ther-
mal sensor is located at the smoke outlet of the stove.
Room temperature
Displays the temperature measured by the accompa-
nying room temperature sensor. The temperature may
vary by +/-
o
C in relation to the temperature measured
by another thermometer.
9
Temperature level
The temperature level-setting runs from "Level "
through "Level ". The level can be changed by press-
ing "+" or "-" which regulates the desired temperature
level up or down. The individual levels are explained in
detail in the following sections.
NOTE: Night reduction automatically puts the system
at "Level ". If, however, the level is subsequently
changed, night reduction is disabled.
REMEMBER:
Never leave a stove after igniting a
fire before ensuring that there are
long lasting flames!
7
8