User Manual HWAM® SmartControl™ Generation 2

18
4 5
6
8
7
2 3
NOTE: After  minutes, the unit will leave the pairing
mode and automatically go into standby mode.
7
Connect the power supply immediately to the stove.
If the supply to the stove is not connected within 
minutes after the wireless room temperature sensor
is plugged into "pairing mode", the pairing will not
succeed, and will have to be restarted.
8
After the room temperature sensor is connected to
HWAM® SmartControl™ the light will briefly turn solid
green and the indicator light will then turn o. Pairing
has been successfully completed. Put on the lid and
screw in again.
1
Turn the unit on its rear end.
2
Unscrew the four screws on the backside (as shown
in the picture) to access the batteries.
3
Remove the lid from the unit.
4
Take one battery out of the unit.
5
Disconnect the power supply to the stove.
6
Press the button on the front of the wireless room
temperature sensor and hold the pressure while the
battery is put back into the unit, until the LED lights
green. When the wireless room temperature sensor
starts up, it will flash green at a fast pace as illustra-
ted below:
Pairing of the room temperature sensor with HWAM® SmartControl™
It may sometimes be necessary to pair the wireless room temperature sensor with HWAM®
SmartControl™. To do this, it is necessary to put the wireless room temperature sensor in pai-
ring mode (see instructions below).